Flexible LED Filament Noodles!

These Filament noodles are a great way to add a little pop to your project and some zazz to your wearables. They're super flexible and can be sewn to fabrics with ease! They move and feel a bit like rubber noodles! But we don't reccomend eating them!

Be sure to keep them away from pets that like to chew on or eat things they shouldn't. Especially cats! They LOVE these things.

These come in two lengths (Select length and color above):

-300mm Length (11.8 in) - 3V 200mA

-1200mm Length (47.24 in) - 24V 300mA

Don't have easy access to 24V DC? Need to power the longer 1200mm filaments off of lower voltages? No problem, just order one of these DC step up units with your noodles: DC-DC Adjustable Step-Up Boost Module. 5-35VDC Outupt @ 2A (3AMP*) (D89)

Or for running them easily at 24V DC, you can power them off of two of our 12V batteries in series (with holders) like in the image below:

You shouldn't expect any longer than about a 30 or so minute continuous run time from a setup like in the image above. Don't worry about over volting them with 24V when running on these batteries, the batteries don't have enough power to damage the LED strings.

It is intended to be soldered to each end. You can use small screw terminals to avoid soldering. We have an in store display set up for these so you can see how cool they look!

We have: Blue, Green, Yellow (More of a warm white 2700k), and Red available in 300mm!

We have: Red, Green, Blue in 1200mm!

Call to check availability as these are super popular!!

We have been carrying these online since early 2021!

And we are the FIRST online and retail store to carry them in the United States!!!

NOTE 1: To prevent filament damage from excessive heat, it is recommended to use a about 20.50V power supply for prolonged use on the 1200mm units.

NOTE 2: These are delicate items. You must handle them properly to prevent damage to them. Do not crease them or bend them more than about 100 degrees. Do not tie them into a knot. Do not use them as string or structural support. Do not pull them through a tight opening. Do not cut them. Do not pull on them, do not try to stretch them. The soft silicone can be picked apart by fingernails if you are not careful. This can also ruin them. There is no way to repair a damaged LED filament. LED filaments are tested for function before shipping. Replacements/refunds will not be sent for damaged filaments due to improper use.