White 12V COB LED Strip with adhesive (2 pack)
- Unit price
- / per
This is a 2 pack of our white COB (Chip On Board) LED strips that come with a strip of adhesive on their back.
These are fantastically bright and are perfect for:
-Computer cases, server racks, status signal lights
-Vehicle installation under the hood, under foot wells, as dome lights, marker lights, DRLs (Daytime Running Lights) and more
-In home lighting and under cabinet lighting
-Much, much more!
SPECS:
12 VDC @ ~150mA
These units are 6.75 inches long and are 0.58 inches wide and 0.12 inches tall. The leads are roughly 12 inches long with pretinned ends.
PLEASE NOTE: For what ever reason, sometimes the Red and Black wires are soldered on opposite their intended polarity. So if you get a "bad strip", try hooking it up backwards.
NOTE: these strips REQUIRE ONLY 12 Volts DC. If you supply any more than 12 V, you need to add a voltage regulator OR a current limiting resistor to the circuit or you will burn the strip up due to thermal runaway. If you are using this in a vehicle, then you MUST do the above. Vehicles charge their batteries at around 13 to 14.5 volts, this is enough to destroy these strips and possibly burn them up. By our calculations, if you want to use these in a vehicle, you should get a 27 ohm resistor in at least 1/2 watt. See link below:
https://vetco.net/products/27-ohm-1-2-watt-resistor
PACK QTY: 2 Strips
White 12V COB LED Strip with adhesive (2 pack)
- Unit price
- / per
Adding product to your cart
You may also like
This is a 2 pack of our white COB (Chip On Board) LED strips that come with a strip of adhesive on their back.
These are fantastically bright and are perfect for:
-Computer cases, server racks, status signal lights
-Vehicle installation under the hood, under foot wells, as dome lights, marker lights, DRLs (Daytime Running Lights) and more
-In home lighting and under cabinet lighting
-Much, much more!
SPECS:
12 VDC @ ~150mA
These units are 6.75 inches long and are 0.58 inches wide and 0.12 inches tall. The leads are roughly 12 inches long with pretinned ends.
PLEASE NOTE: For what ever reason, sometimes the Red and Black wires are soldered on opposite their intended polarity. So if you get a "bad strip", try hooking it up backwards.
NOTE: these strips REQUIRE ONLY 12 Volts DC. If you supply any more than 12 V, you need to add a voltage regulator OR a current limiting resistor to the circuit or you will burn the strip up due to thermal runaway. If you are using this in a vehicle, then you MUST do the above. Vehicles charge their batteries at around 13 to 14.5 volts, this is enough to destroy these strips and possibly burn them up. By our calculations, if you want to use these in a vehicle, you should get a 27 ohm resistor in at least 1/2 watt. See link below:
https://vetco.net/products/27-ohm-1-2-watt-resistor
PACK QTY: 2 Strips
You may also like
You may also like
Recommended products
Most orders arrive in 2-3 days
Our staff will go the extra mile to find your solution
A favorite of the Seattle area since 1989
PCI DSS compliant checkout