1" Smurf Tube - 50Ft - Liquid-Proof Tight Smooth Wall Conduit - Electri-flex Liquatite
1" Smurf Tube - 100Ft - Liquid-Proof Tight Smooth Wall Conduit - Electri-flex Liquatite
MFG Part Number: NM-13-50
-Oil Resistant
-Waterproof (If used properly)
-Outdoor Sun/UV Resistant
-Direct Burial
-Solid, NON-SPLIT conduit. (read below to see how to run your wire inside).
-1 inch for use with 1 inch fittings.
Sold in 50 foot box. Not sold by the foot. Comes only in grey. Wire NOT included.
Call for in store stock status.
GUIDE FOR PULLING WIRE:
Get string, a vacuum and your wire.
Tie a small bit of plastic bag to one end of the string. Feed it into the tube. It should be a slightly snug fit but not too much resistance. Go to the other end of the tube and use the vacuum to suck the string throgh the pipe. Be sure not to suck the sting INTO the vacuum and also tie off the other end of the string so that you don't pull it too far through. Then tie the string (or tape) to the wire and pull your wire through. Don't have any kinks or bends when doing this or you will have a VERY tough time feeding the wire. Same goes for pulling the string through with the vacuum.
1" Smurf Tube - 100Ft - Liquid-Proof Tight Smooth Wall Conduit - Electri-flex Liquatite
MFG Part Number: NM-13-50
-Oil Resistant
-Waterproof (If used properly)
-Outdoor Sun/UV Resistant
-Direct Burial
-Solid, NON-SPLIT conduit. (read below to see how to run your wire inside).
-1 inch for use with 1 inch fittings.
Sold in 50 foot box. Not sold by the foot. Comes only in grey. Wire NOT included.
Call for in store stock status.
GUIDE FOR PULLING WIRE:
Get string, a vacuum and your wire.
Tie a small bit of plastic bag to one end of the string. Feed it into the tube. It should be a slightly snug fit but not too much resistance. Go to the other end of the tube and use the vacuum to suck the string throgh the pipe. Be sure not to suck the sting INTO the vacuum and also tie off the other end of the string so that you don't pull it too far through. Then tie the string (or tape) to the wire and pull your wire through. Don't have any kinks or bends when doing this or you will have a VERY tough time feeding the wire. Same goes for pulling the string through with the vacuum.